3
www.stairslight.com
Installation
The controller should be installed by someone with skills in the field of electrical engineering,
preferably a certified specialist. The controller must be installed with the power off!
Power supply for controller and LEDs should be stabilized with an adequate current capacity
depending on the amount and length of the used LED strips or 12V LED light. Do not use a power
supply (type 12) for halogens — the controller will be damaged immediately! The controller is designed
for a voltage of 12 V DC (stabilized). Maximum current per output is 5 A. Do not exceed this value.
The first step is to connect the lights (LED strips or spots) to the controller. When you connect
the 12V power supply, the stairs lighting should turn on with minimum brightness (so-called stairs
illumination effect). When the
TOP
button on the controller body is pressed, the lighting up of the steps
one by one should begin. If this does not happen, the way the LED lighting is connected should be
checked carefully. Similarly, the animation after the button
BOT
is pressed should be checked – in
this case , the stairs lighting should take place downwards.
It is recommended to adjust the sensor response to movements without connecting them to the
inputs of the controller. The sensor pulse time (TIME) must first be set to extreme minimum and it
should not be changed during adjustment. The sensitivity (range) also should be set at the minimum
- but this parameter can be adjusted. In some sensors, the support function should be disabled or
properly adjusted ( triggered). Only after the proper operation is obtained of the sensors, they can
be connected to the controller.
Only after obtaining the proper light animation, you can begin to connect the motion sensor.
The last step is time intervals adjustment. The best way is to do it after a few days of using the
stairs in order to determine as accurately as possible the necessary changes. We recommend you
do not adjust the parameters without a specific reason. For greater safety, changing the parameters
are blocked by the factory (see the chapter on adjusting the controller)
