18
www.stairslight.com
Flickering 11 – Sensors lock.
This is an important parameter when installing motion sensors. In some cases, motion sensors
cannot be placed in an ideal direction. This happens when a person starts going down the stairs,
and turns on all the lights, as if another person walked the stairs. This can be prevented by blocking
the sensors in two ways. When you release the button after the first impulse, the sensor opposite to
the one that started the animation is blocked. When released after the second impulse, both sensors
are blocked. The lock lasts for the duration of the animation to the end of lighting time of the stairs or
turning on the backlight. From that point on the two sensors are again active and animation can be
run in either directions. You can disable the lock by releasing the button immediately after the end of
the flickering. In a new controller, the lock is turned off.
Flickering 12 – Fade out animation.
If another person comes up the staircase, all the lights light up. They can be turned off by a
smooth, slow fade or animation of the steps. Releasing the button immediately after the flickering
sets the first option, and releasing after one impulse - the second one.
Flickering 13 – Delayed start of the controller.
Some motion sensors, after the power is turned on, transmit a long impulse,often lasting dozens
of seconds.. It can cause an incorrect operation of the controller (eg a constant light). In this case, you
can set a delayed start of the controller — about 1 minute. At that time, after powering of the whole
system, the controller does not respond to the buttons or sensors. This is indicated by the blinking of
all steps. Normally, the delayed start function is on. Releasing the button immediately after flickering
turns delayed start off, and after one impulse – turns it on.
Reset of the controller.
If the user incorrectly changed the parameters and it had an impact on the controller operation,
you can easily restore the factory settings of the parameters. Use the
RES
(Reset) button on the top
of the controller. As it is recessed into the case, to press it use a proper stick, for example a match.
To reset the controller, press and hold the
RES
button. After a while, the
LED
will flash. The button
must be pressed continuously during all the flashing time. After the
LED
stops to flash and turns off,
you can release the button. Reset is confirmed by five short flashes of the
LED
.
At this point, the parameters are reset to their default settings and the controller will work normally
in standby mode, waiting for a signal from the button or sensor.
Turn on stairs on permanently.
To turn the light of the stairs on permanently, press a push-button connected to the Input No. 4
To turn off the permanent light, press again the same push-button. The controller then switches to
normal functioning.
