32
CUSTOMER MANUAL
FRONT HUB MOTOR SYSTEM
8.5.1 Enter into “SETTING” interface
After switching on the display, briefly press
(<0.5S)
for two times to enter into the
“SETTING”interface. The interface includes
the three options as “display setting”,“Infor
mation”and“EXIT”. Briefly press (<0.5S)
or to switch the options and then briefly
press (<0.5S)
to confirm and enter into
the option. Select “EXIT”and briefly press
(<0.5S)
to exit the interface or briefly
press (<0.5S)
for two times in any inter-
face to exit the set inface. The set dates are
saved for the two exit mode. If there is no
any operaion within 20s and then exit the
set interface, no any dates are saved.
8.5.2 Enter into“Display setting”interface
In “SETTING” interface, briefly press (<0.5S)
or to select “display setting” and then
briefly press (<0.5S)
to confirm and enter
into “display setting”. There are thirteen set
options in the interface.
⑴
“Unit”--- unit switch between the km
and mile
Briefly press (
<
0.5S)
or to select“Unit”,
and then briefly press (<0.5S)
to enter
into the set interface. Briefly press (<0.5S)
or to select “Metric”/ “Imperial”, and
then briefly press (<0.5S)
to save the set
and exit back to“Unit”interface. Briefly press
for two times (interval time is less than
0.5S)to exit back to main interface,or select
“BACK”
→
“EXIT”to exit back to the main
interface.
⑵
“Brightness”--- set display brightness
Briefly press (
<
0.5S)
or to select
“Brightness”and then briefly press (<0.5S)
. This moment, briefly press (<0.5S)
or
to switch the percentage as“100%”/“75%”
/“50%”/“30%”/“10%”.100% is the highest
brightness, 10% is lowest brightness. After
select the brightness percentage, briefly
press (<0.5S)
again to save the set and
exit back to“Brightness”. Briefly press
for
two times (interval time is less than 0.5S) to
exit back to main interface, or select “BACK”
→
“EXIT”to back the main interface.
