BADU JET Smart, Перевод оригинального руководства по эксплуатации, Страница: 72 / 316

Installation
18 EN 06|2020
5 Installation
5.1 Installation site (Qualified specialist)
5.1.1 Outdoor installation
 In order to increase the pump's service life, provide simple
weather protection.
5.1.2 Installation position
 The unit is normally installed on the narrow side of the pool
with a recommended minimum pool length of 4 m.
 From a pool width of 4 m, installation on the longer side is
also possible.
 For round and oval pools made from smooth sheet steel or
plastic, a minimum radius of 2 m is required.
 For round and oval pools made from made from stone or
concrete, a flat surface with a minimum width of 480 mm is
required.
 The water depth at the position of installation should be
between 1.2 m and 1.5 m. Thus the massage hose can be
used appropriately and optimally.
5.1.3 There must be ground drainage
 Calculate the size of the ground drain according to the
following criteria:
– Size of the swimming pool.
– Circulation flow rate.
5.1.4 Ventilation and aeration
 Ensure sufficient ventilation and aeration. The ventilation and
aeration must ensure the following conditions:
– Prevention of condensation.
– Minimum distance from fan cover to the wall: 120 mm.
– Cooling of the pump motor and other system components,
for example switch cabinets and control units.
– Limitation of the ambient temperature to maximum 40 °C.
5.1.5 Structure-borne and airborne noise transmission
 Observe regulations for structural noise protection, for
example DIN 4109.
 Install the pump in a manner which reduces structure-borne
and airborne noise transmission. Vibration-absorbing
materials are suitable bases. Examples:
– Anti-vibration
buffers
– Cork lining
– Sufficiently hard foam