LMS_MDS2000_BA_02_0810
Safety features
Page 1/44
1. Installation manual
1.1. Safety
features
1. Before installing or using this product, please read the instruction manual
thoroughly.
2. Unpacking: Please check that the product is complete and free from any
damage (check with the further packing list).
3. Only qualified individual should install and/or repair this product.
4. Unplug the MDS 2000 from the electrical outlet before you clean it. Use a clamp
cloth for cleaning and do not use liquid or aerosol cleaners.
5. Do not place the MDS 2000 on an unstable surface that may allow the unit to
fall.
6. Never place the MDS 2000 near or over a radiator or heat register.
7. Use the type of power source indicated on the label (AC power). If you are not
sure of the type of power available, consult your supplier or local electric
company.
8. The MDS 2000 must be equipped with a plug having a third (grounding) pin,
which fits only into a grounding-type outlet. This is a safety feature. The MDS
2000 should not be used without a properly grounded outlet. Failure to properly
ground the MDS 2000 may cause damage to the unit or the data stored.
9. Do not put the MDS 2000 where the cord will be walked on.
An extension cord is not recommended for use with the MDS 2000. If you use
an extension cord, make sure that the total of the ampere ratings on the
products plugged into the extension cord does not exceed the extension cord's
ampere rating. Also, make sure that the total of all products plugged into the
wall outlet does not exceed 15 amperes.
11. Unplug the MDS 2000 from the wall outlet and have it repaired by a qualified
service person under the following conditions:
a) When the power cord or plug is damaged or frayed.
b) If liquid has been spilled into it.
c) If it has been exposed to rain or water.
d) If it does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions
since improper adjustment of other controls may result in damage and loss
of data.
e) If it has been dropped or damaged.
f)
If it exhibits a distinct change in performance, indicating a need for service.
Warning
Failure to adhere to these safety instructions may result in serious bodily injury.