Back to Basics cocoa grande, Инструкция по эксплуатации

Страница: 5 / 36

5
U
SING
Y
OUR
C
OCOA
G
RANDE
™
CONTROL BUTTONS:
HEAT & HI SPEED- Mixes and heats your drink at high speed. High
speed is perfect for creating frothy drinks.
HEAT & LO SPEED – Mixes and heats your drink at low speed. Low
speed is perfect for drinks that don’t need much froth.
CANCEL – Stops any function. “CANCEL” can be pressed at any
point in the cycle to turn the appliance off. Buttons will flash red to
indicate that the appliance is still plugged in.
FROTH & DISPENSE – Stirs your drink at a high speed, without
adding heat, to mix and froth your drink for serving.
Note: After a button has been pressed to make a selection, the
indicator light will glow blue.
The measurements used below produce 60 ounces. Refer to the
Ingredients Chart to determine usage for alternate serving sizes.
1. Place mixing container with heating base on to the motor base.
Remove the lid from the mixing container.
2. Pour 60 ounces of water or milk into the mixing container.
Note: Do not fill the mixing container past the 60 ounce “Max
Fill” line.
3. Add 1 cup of your favorite instant mix.
4. Replace the lid on to the mixing container, making sure that the lid covers the
pour spout.
5. Plug the Cocoa Grande™ into a 120 volt, AC outlet only.
6. Press the “HEAT & HI SPEED” or “HEAT & LO SPEED” button. The selected
control button will glow blue and your Cocoa Grande™ will begin to mix and
heat. When the mixture reaches the “Perfect Temperature,” the appliance will
automatically go idle. Once the beverage cools down, the appliance will
automatically reheat and remix back to the “perfect temperature.” The light will
remain blue and the appliance will remain on until the control button, or
“CANCEL,” is pressed. At any time during the mixing and heating process, you
may press the “CANCEL” switch to turn the appliance off. The control lights will
flash red until the appliance is unplugged or a selection is made. Selecting
another speed setting will change the operation and the selected control button
will glow blue. Note: A full 60 ounces takes approximately 13 minutes.
7. Once the appliance automatically goes idle, place a cup underneath the
dispensing valve and press the “FROTH/DISPENSE” button. This setting will
mix the beverage while you dispense so that a rich layer of froth is dispensed
into your cup along with the hot drink.
8. Press down on the dispensing valve lever to dispense the hot drink into your cup
while the motor is mixing the beverage. After dispensing the beverage, press
the “CANCEL” button.
9. When the container has less than 1 cup of liquid remaining or is empty, press
the “CANCEL” button. Note: The appliance will remain on until you press