Back to Basics cocoa grande, Инструкция по эксплуатации

Страница: 6 / 36

6
“CANCEL.” The control buttons will continue to flash red after “CANCEL” has
been pressed, indicating that the appliance is plugged in, but not in operation.
INGREDIENTS CHART
CUPS 2 4 6 8
LIQUID Milk/Water 16oz. 32 oz. 48 oz. 60 oz.
POWDER MIX with Milk 4 tbsp. 8 tbsp. 12 tbsp. 16 tbsp.
POWDER MIX with Water
4 tbsp. 8 tbsp. 12 tbsp. 16 tbsp.
Note: Different instant cocoa, coffee, and tea mixes may vary from the quantities shown in this
chart. Use the quantities specified on the packaging of the specific instant hot drink mix for
exact measurements, or adjust to taste. You can use the included cup measuring scoop to
measure.
“PERFECT TEMPERATURE” FEATURE
The Cocoa Grande
™
is designed to maintain the “perfect temperature.” Once the hot
beverage reaches the “perfect temperature,” you will hear the motor stop running
and the mixing paddle stop mixing, but the blue indicator light will still be lit. The
appliance is now idle but still on. Once the hot beverage cools down, the appliance
will automatically reheat and remix back to the “perfect temperature.” You may at
any time press the “CANCEL” button to turn the appliance off. THE APPLIANCE
WILL CONTINUE TO CYCLE ON AND OFF UNTIL THE “CANCEL” BUTTON IS
PRESSED. The control buttons can be pressed at any time to change the mix
settings. Pressing the control button again will put the Cocoa Grande™ in idle mode
and the lights will flash red until a selection is made or the appliance is unplugged.
C
LEANING
Y
OUR
C
OCOA
G
RANDE
™
The Back To Basics
®
Cocoa Grande
™
should be cleaned after every use. Note: Do
not wash any parts in the dishwasher and do not immerse the motor base or mixing
container in water or any other liquid.
1. Unplug the appliance from the electrical outlet. Allow the entire appliance to
cool before cleaning.
2. Remove the mixing container from the motor base.
3. Pour out any unused portion of the hot drink mixture.
4. Add hot water and a couple drops of dish soap to the mixing container. Wash
and rinse. Note: For any difficult to remove build-up, use a nylon scrub
pad.
To
remove build-up around the edge of the mixing container and under the gasket,
use the corner of a nylon scrub pad. It may help to let hot, soapy water sit inside
the mixing container for a few minutes. Do not immerse the heating base in
water or any other liquid.
5. Separate the lid and measuring scoop, remove and disassemble the dispensing
valve as described below. Wash lid, cup measuring scoop, and dispensing
valve pieces in hot, soapy water. Rinse and dry pieces thoroughly before
reassembling.
6. Wipe the exterior of the motor base and mixing container with a soft, damp
cloth.
7. Periodically sanitize mixing container and gasket. Place mixing container on the
motor base and add 4 cups of water and ¼ tsp. unscented bleach to the mixing