BABYTREND Secure-Lift 35, Руководство пользователя

Страница: 29 / 36

55 56
7.0
INSTALLATION
7.0
INSTALLATION
1. Safety Seat with Base: Make sure the
vehicle is parked on level ground. Lock
the Safety Seat onto the Base and check
that the Safety Seat is level side to side
on the vehicle seat (Fig. 55-1). Check the
Seat Angle Indicator that matches the
weight of your child.
• If the Seat Angle Indicator shows the
bubble centered between the lines, the
seat is installed at the proper level of
recline for occupants 4-22 lb. (Fig. 55-2).
• If the Seat Angle Indicator shows the
level line parallel with the ground, the
seat is installed at the proper level of
recline for occupants greater than 22 lb.
to 35 lb. (Fig. 55-3).
• If the Seat Angle Indicator bubble level
(4-22 lb.) is not centered or
level line (23-35 lb.) is not parallel with
the ground, extend the elevation foot,
See section 7.5 To Deploy Elevation
Foot, under the front of the base at the
foot end to achieve the correct position
(Fig. 55-4). If the correct elevation
can not be achieved see section 7.5
Elevation Aids . Re-tighten the vehicle
seat belt as instructed in section,
securing the Safety Seat or Base in
the Vehicle.
Fig. 55-1
Fig. 55-3
Fig. 55-4
2. Safety Seat without Base:
Check that the Safety Seat is
level side to side on the vehicle
seat. Check the Seat Angle
Indicator that matches the
weight of your child (Fig. 56-1).
Fig. 56-1
Fig. 56-2 Fig. 56-3
• If the Seat Angle Indicator line is not level, the Safety
Seat is either too upright or too reclined . If the Safety
Seat is too reclined adjust the Safety Seat as shown in
(Fig. 56-2), until the level indicator shows level . If the
Safety Seat is too upright, place a tightly rolled towel, or
pool noodle, under the foot end of the Safety Seat until
the level indicator shows level (Fig. 56-3). Re-tighten the
vehicle seat belt as instructed in section Securing the
Safety Seat or Base in the Vehicle.
Fig. 51-2
Seat Angle
Indicator
Center
Parallel
To Ground Line