BABYTREND Secure-Lift 35, Руководство пользователя

Страница: 24 / 36

45 46
7.0
INSTALLATION
7.0
INSTALLATION
4. See (Fig. 40-2) for the proper threading
of the vehicle belt through the Base and
(Fig. 45-1) for the proper threading of
the belt through the Safety Seat
without the Base.
5. Buckle the seat belt being careful that the
seat belt is not twisted and is securely
latched into the appropriate buckle, and
not the adjacent buckle (Fig. 46-1).
6. Proper installation of the Safety Seat
or Base requires that the seat belt be
very tight. To tighten the seat belt, push
down hard with your knee or hand on the
Safety Seat or Base while pulling and
tightening the seat belt. Check that there
is no slack in the seat belt on either side
of the Safety Seat or Base, or anywhere
along the path of the belt, and that the
seat belt is tight from end to end.
(Fig. 46-1 and 46-3). Adjust handle
to the correct position seen below in
(Fig. 45-2).
ONLY use Rebound or Storage
Handle positions in vehicle. Use
Storage position for children
greater than 22 lb or if feet can
touch the handle (Fig. 45-2).
7. To tighten a lap belt only:
• An automatically retracted lap seat belt
is tightened by feeding belt back into its
retractor while pushing down hard on the
Safety Seat or Base. Make sure that the
retractor locks the lap belt into place and
that the belt remains very tight (Fig. 46-4).
• A manually adjusted lap seat belt is
tightened by pulling on the free end
of the seat belt while pushing down
hard on the Safety Seat or Base. If you
experience difficulty tightening the seat
belt, unbuckle the seat belt, tighten the
seat belt a small amount and re-buckle
the seat belt. Repeat this procedure
until the seat belt is very tight around the
Safety Seat or base. Check that the seat
belt remains very tight around the Safety
Seat or base (Fig. 46-5).
Fig. 46-5
Fig. 46-4
Fig. 46-1 Fig. 46-2 Fig. 46-3
Fig. 45-1
Lap/Shoulder Belt
Lap Belt only
Fig. 45-2
Rebound
Storage