BABYTREND Secure-Lift 35, Руководство пользователя

Страница: 27 / 36

51 52
7.0
INSTALLATION
7.0
INSTALLATION
6. Proper installation of the Base requires
that the LATCH webbing be very tight. To
tighten the webbing, push down hard with
your knee or hand on the Base while pulling
upward on each webbing end. The webbing
will automatically lock in place. Check that
there is no slack in the webbing on both
sides of the base and that the base is tightly
installed (Fig. 52-2 and 52-4).
1. Remove any toy or other objects attached to carry handle before
installing car seat in vehicle.
2. Locate a LATCH seating position as identified in your vehicle
owner’s manual. Some LATCH seating positions may require
deploying of anchors, or installation of guides.
3. Remove the Safety Seat from the base
by squeezing the base release handle
located under the center of the head end
of the Safety Seat and lifting upward on
the Safety Seat (Fig. 24-1).
4. Remove the LATCH Push On Connectors
from their storage position inside the base
(Fig. 51-1). Place the Base in the rear-
facing position in a forward facing vehicle
seat as shown in (Fig. 51-2). The Child
must face the rear of the vehicle and
Safety Seat must be placed in a vehicle
seat that faces forward.
5. Locate the LATCH anchors in
the vehicle seat (Fig. 51-2). Once
located, snap the Safety Seat LATCH
connectors onto the steel rod. Listen
for the click and check that both
connectors are firmly attached to the
anchor rods by pulling outward on the
connectors.The LATCH connector
indicator window will turn Green when
the LATCH connector is attached to
the LATCH Anchor (Fig. 52.1).
Fig. 52-2
Snap onto anchors
Push On LATCH
Connector Storage
Fig. 51-1
Fig. 51-2
Latch
Fig. 52-3 Fig. 52-4
LATCH Connector
Indicator Window
Fig. 52-1