BabyLove BL620A 2010, Инструкция

Страница: 14 / 29

26
HOW TO USE HOW TO USE
27
INSTALLING UPPER ANCHORAGE STRAP
A. Locate the child restraint anchor fitting
in the car that is directly behind the
seat location in the rear seat you
have chosen. Refer to the car owner’s
manual for the location (If there is no
anchorage fitting then refer to page 48 for
instructions in adding an anchor fitting.)
Connect the Upper Anchorage Strap
Attachment Clip to the Anchor Fitting.
Lengthen the strap by pressing the
adjuster button (1) and pull the strap (2)
so that the strap is ready to attach to
the Carrier.
THIS UPPER ANCHORAGE STRAP
MUST ALWAYS BE FITTED WHEN THE
CARRIER IS USED IN THE CAR.
Attachment Clip
Car's Anchor Fitting
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
1
2
3
B. While the Carrier is out of the car, store the upper anchorage strap between the
stabilising bar and the car seat back so that it will be ready for use when the
Carrier is put back in the car.
Always attach hook and remove slack.
J. Some car seats do not provide enough
support to hold the base up at the
required angle to enable the Carrier to be
connected to the Base. Use the adjustable
foot to achieve the level. See page 23.
If extra support is required to achieve the
desired level then a tightly rolled towel can
be used.
Rolled towel or similar.
IMPORTANT:
Always anchor the base with a vehicle belt, even when the restraint is not installed
on it. An unanchored base can injure passengers in a sudden stop or accident.