BabyLove BL620A 2010, Инструкция

Страница: 15 / 29

28 29
HOW TO USE
HOW TO USE
PLACING BABY IN CARRIER
When positioning baby into Carrier make sure baby’s back is fully supported
onto the flat section and the baby’s nappy area (bottom) is resting in the bottom
curvature as shown. It is recommended that bulky nappies are not used when baby
is travelling in the Carrier as they can cause incorrect positioning of the baby’s back
in the Carrier.
Bottom curvature of Carrier
Flat section of
Carrier
A. Loosen Harness Straps by pressing
the Harness Adjuster while grasping
both the Shoulder Harness Straps
and pulling out the desired amount
of slack.
Press the Harness
Adjuster and pull Harness
Straps to loosen.
Buckle Tongue Holder on both
sides of the Carrier. Push
tongue inwards to engage.
B. Move the two harness tongues to the
outer extents of the Carrier and engage
into the Buckle Tongue holders.
Move the harness buckle towards the
Harness Adjuster.
C. Place baby into Carrier lying on their
back so that the buckle is between the
baby’s legs. Make sure baby is dressed
to allow the Harness Buckle to be pulled
up between baby’s legs e.g. a jump suit.
Never wrap the baby in a blanket before
placing in the Carrier. Ensure that baby’s
arms and legs are free.
NOTE: If the blanket is required for warmth
place it over the baby when harnessing is
complete.
NOTE: Discontinue using the Padded Insert if it causes over heating, discomfort or
you need more room for the child to grow.