2.6
4G Lift Dialer & 4G Lift Dialer Box
Installation
2.7
4G Lift Dialer & 4G Lift Dialer Box
Installation
2.4. BEFORE POWERING LIFT DIALER ON
Place 4G Lift Dialer where you prefer, in a zone with a good GSM signal, and go on as follows:
1. Open the SIM holder by slightly pressing and pushing it horizontally toward
the internal side of the card.
Now
insert the SIM card
. Pay attention to the SIM cut corner and be sure
the golden contacts of the SIM are turned downwards when closing the SIM
holder.
Close the SIM holder by slightly pressing and pushing it horizontally in the
opposite side to block it and correctly fix the SIM.
2. Connect the LTE antenna you find in the package to the golden SMA
connector. Screw it clockwise; in case of problem do not force but remove
the antenna and try again.
Apply the magnetic base of the antenna only on metal zone,
without connection to earth.
Please use eventually the metal support, find in the package,
fixed it to the wall.
3. Connect
pins 5-6 of 4G Lift Dialer to pins 1-2 of Voice Box.
PINS CAN BE CROSSED.
For a good audio quality use a twisted pair for the connection. Otherwise you can use two unused wires already present in the
car cable or use the the wires already present and used for the bell after having modified the system as described in paragraph
RELAY1: BELL MANAGEMENT.
In this case the audio quality could not be the best one.
4. Connect eventually the external button (or buttons) on Voice Box.
5. Now power
4G Lift Dialer
on following the polarity:
pin 21 : 12-24 Vdc
pin 22 : GND
We suggest to use Digicom power supply for 4G Lift Dialer:
Switching power supply (IN: 100-240 Vac / 50-60Hz / 0,5A – OUT 12 Vdc / 1A) (code 8D6065)
USE ONLY A LIMITED POWER SOURCE (LPS) POWER SUPPLY, ACCORDING TO EN 60950-1 (2.5) REQUIREMENTS.
6. Check the LED power on:
Power
:
green fixed ON
GSM
:
at the beginning OFF; after the affiliation to the GSM network it is yellow fixed ON or blinking.
7. For the first alarm call after powering, wait 1 minute, in this time 4G Lift Dialer completes the internal initializations.
SIM
1
5
10
15
20
BATTERY
SCREW TERMINAL
ANTENNA
22
