B.Pro SAW 1, Руководство по эксплуатации

Страница: 11 / 48

B.PRO Food Distribution Carts SAW/SAG/BTW9x7
– 7 –
Food distribution cart SAW/SAG with sliding cover
Close the sliding cover before changing your position. The required steering
and braking control is only ensured if the sliding cover is closed.
Food distribution cart SAW/SAG with fold-down deposit shelf
Fold down the deposit shelf before changing your position.
When the unit doors are closed, the unit can be tilted to an angle of 10°. Only
sloping surfaces should be crossed with tilt of < 10°.
To minimize the danger of damage to the rollers, avoid overloading the rollers:

Do not move the unit when the locking brakes are locked

Avoid impacts

Do not traverse bumps or steps

Do not traverse uneven floors
The unit is to be pushed only, never pulled.
Always push the unit using both hands. Depending on the weight of the unit,
if you push it with just one hand it is possible you would not be able to apply
the brakes quickly enough.
Be careful to ensure that your hands are not pinched (danger of crushing)
between the push handles and walls or other objects (e.g. cabinets).
Two people are required to move the unit over ramps or sunken areas (one
at each end of the unit).
Shutting down Unplugging the power plug
Do not unplug the power plug if the unit is switched on. Otherwise the unit
electrical system can be damaged.
Cleaning and care Hygiene
The provisions of the hygiene guidelines 93/43/EEC as well as your national
hygiene regulations must be complied with.
The unit fulfills the requirements of the hygienic design H 1.
Cleaning frequency
Clean the unit thoroughly after each use.
Cleaning methods
Use only approved cleaning methods.
Do not use a steam jet device or high-pressure cleaner.
Power plug
Unplug the power plug before cleaning the unit. Water seeping into the unit
can cause a short-circuit. If this happens, there is a risk of death by electric
shock.
Cleaning water, water condensation
A danger of slipping exists if cleaning water runs out of the unit during or after
cleaning.
Completely wipe up any water which runs out of the unit.
Thoroughly dry the unit after cleaning. Remove cleaning water and water con-
densation from the floor of the unit interior.