B. Braun Aquaboss CCS, Инструкция по эксплуатации

Страница: 38 / 75

System data parameters
Section 1 – Operating Instructions
Rev. 2.8 Date 2019-02-04
Software version 1.00
CCS
Chapter 8
Page 8-7
8.9 Maintenance program, menu item 7
8.9.1 Maintenance program, setting outputs
8.9.2 Maintenance program, observing inputs
Under menu 7, maintenance program, the active elements (pumps, sole-
noids) can be replaced under 7.1 Outputs. The digital switching states of
the inputs can be regulated under 7.2.
7 Maintenance pgm.
7.1 Outputs
7.2 Inputs
7.3 Venting
Esc
 
Enter
The menu can only be requested through an access code.
Note: When the system enters menu 7.1 the normal operating mode is
interrupted and all outputs are set to 0.
When menu 7.1 is quit, a switch-on reset is carried out.
The pumps are operated at 10% of the maximum speed
0/1 Delete/set output.
7.1 Outputs
Enter code
XXXX
Esc
 
Enter
SV Y1.1 0/1
Pump M1.1 0/1
SV Y1.2 0/1
Pump M1.2 0/1
SV Y2.1 0/1
Pump M2.1 0/1
SV Y2.2 0/1
Pump M2.2 0/1
SV Y3.1 0/1
Pump M3.1 0/1
SV Y3.2 0/1
Pump M3.2 0/1
Rel. K1 operation 0/1
Rel. K2 reserve 0/1
Rel. K3 alarm 0/1
Rel. K4 cont.empt 0/1
Signal buzzer 0/1
Esc
 
Enter
The menu allows operators to observe the switch states of the digital
inputs even during normal system operation.
0/1 = Input not set / set.
Inp. level 1.1 X
Inp. level 1.2 X
Inp. level 2.1 X
Inp. level 2.2 X
Inp. level 3.1 X
Inp. level 3.2 X
Inp. rem. control X
Inp. reserve X
Inp. security ch. X
Esc
 
Enter