Aztech NETCARD AZ-NC2100, Руководство пользователя

Страница: 35 / 49

35
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Chapter 4 — Installing the Network Card Drivers
DeviceNo=@0A ; This keyword is used to desinate a NetCard adapter
; by assigning it's PCI Device number when more
; than one adapters exist on one system.(must be
; used with 'BusNo' keyword)
Speed= 100/10 ; This keyword is used to force NetCard adapter to
; speed 10M or 100M mode. If not present, the driver
; will auto-detect the speed.
Installation Procedure:
Before you start with the installation procedure, make sure that the adapter is
properly installed and configured. Similarly, make sure that your Microsoft
Network Client is properly installed.
(If not, the installation utility SETUP.EXE is located on Microsoft Network Client
v3.0 for MS-DOS Disk. Run SETUP.EXE from Disk and the SETUP program
screen will appear. You must complete each of the questions where the options
are specific to your needs. The installation procedure will transfer files to a specific
directory on the client and modify existing configuration files to fit your specific
needs.)
1. Change to the Microsoft Network Client subdirectory, and run SETUP.EXE .
2. The screen will display some infomation. Press < Enter >.
3. Responds to the screen prompts, selecting " Change Network
Configuration ", then press < Enter >.
4. Move the highlight to " Add Adapter ", press < Enter >.
5. Select " Network adapter not shown on list below... ".
6. Place the NetCard Installation CD into your CD-ROM drive,and specify
your pathname D:\NDIS2\NDIS2DOS ,then press < Enter >.
(Assuming your CD-ROM Drive is D. Else, substitute the drive letter accordingly.)
7. Follow screen instructions to complete the process. Simply pressing
< Enter > for each screen display will select the default options. Press < Enter >
until you reach the display prompting you to reboot your system.