Azbil ACTIVAL, Спецификации и инструкции, Страница: 4 / 20

AB-7356-U
4

Model Numbers
Model VY5430F00XXS-019
Model number is assigned for the valve combined with the actuator. Model number label is attached to the yoke.
Base
model
No.
Actuator / Valve Actuator Valve
Fixed Description
Control
signal
Rating /
Material
Size/Cv Fixed Size/Cv
VY54 Motorized three-way valve with flanged connection
3 4 mA DC to 20 mA DC input with 2 V DC to 10 V DC feedback output
0 145 psig /Gray cast iron*
F
NEMA 4X and IEC IP54 protected and standard torque type actuator
with terminal block
(Mountable valve sizes: 2" to 3")
00 Fixed
51 2” / 45 Cv value
61 2
1
/
2
” / 70 Cv value
81 3” / 100 Cv value
S-019 Fixed
* This product was designed and manufactured conforming to the JIS (Japanese Industrial Standards, JIS10K / FC200).

Specifications
For weight of the ACTIVAL, refer to the table shown in the section Dimensions .

Valve and actuator (as a single unit) specifications
Item Specification
Environmental conditions Rated operating conditions Transport/storage conditions (packaged*
2
)
Ambient temperature*
1
-4

F to 122

F (-20

C to 50

C), fluid no
freezing
-4

F to 158

F (-20

C to 70

C)
Ambient humidity 5 % RH to 95 % RH
Vibration 16.1 fps
2
(4.9 m/s
2
), 10 Hz to 150 Hz 64.3 fps
2
(19.6 m/s
2
), 10 Hz to 150 Hz
Notes:

1 Do not allow the fluid to freeze.

2 Actuator shall be packed during transport.
Installation locations Indoor (salt air, corrosive gas, and organic solvent must be avoided.)
Outdoor (the optional outdoor cover must be used. Direct sunlight, salt air, corrosive gas,
and organic solvent must be avoided.)
Installation orientation Installable in any position ranging from upright to sideways (90

tilted.)
*Always install in upright position outdoors.
Position for shipment Port A 100 % (fully open) preset at factory.
Weight VY5430F0051S-019: 30.9 lb (14 kg)
VY5430F0061S-019: 40.8 lb (18.5 kg)
VY5430F0081S-019: 44.1 lb (20.0 kg)
Insulation resistance Between terminal and case: 5 M

or higher at 500 V DC
Dielectric strength Between terminal and case: 500 V AC/min with 5 mA or less leakage current