11
Administrator Guide – AzaCall200 VOIP Multi-Protocol Gateway
Chapter 4.
Configuring TCP/IP Protocol for User
PC
This chapter explains the procedures used in configuring the TCP/IP protocols on the user’s PCs
running different operating systems. It is mandatory that users follow the steps exactly as listed
below so that the gateway device will operate normally.
4.1. Introduction
To configure and communicate with this device, each PC on the user’s LAN must install TCP/IP
protocol. If the user enables static IP addressing, make sure the user PC resides in the same
subnet as the device’s LAN port. In
Bridge Mode
with the WAN side of the gateway device in
DHCP mode, the default IP Address is 172.25.25.1 and default subnet mask: 255.255.255.0 once
the PC connects to the WAN side. In
Gateway Mode
, the IP Address of the LAN port is
172.25.25.1 and the subnet mask is 255.255.255.0. The TA device is set to bridge mode by
default.
4.2.
Windows 98/Me
1.
From the
Start
menu, click
Settings
, and then click
Control Panel
.
2.
Double-click
Network.
3.
On the
Configuration
tab, check if
TCP/IP protocol
is installed on the components list.
4.
If yes, go to step 8. If no, then click
Add
.
5.
Highlight
Protocol
and click
Add
.
6.
Select
Microsoft
from the
Manufacturers list
and select
TCP/IP
from the
Network
Protocols list
.
7.
Click
OK
. User will see
TCP/IP
displayed on the network components list.
8.
Highlight
TCP/IP
and click
Properties
.
9.
Select the
IP Address
tab and check
Specify an IP address
.
10.
Set
IP address
as 172.25.25.1,
Subnet mask
as 255.255.255.0 and press
OK
.
