6
Administrator Guide – AzaCall200 VOIP Multi-Protocol Gateway
2.3.
Powering Up & Initialization
2.3.1. LED
Status
1.
When plugged into the appropriate electrical outlet, the gateway device will automatically
launch its self-diagnostic process. Three indicator lights (LED): PWR, WAN, and ENET,
will light up steadily. Wait for about 15 seconds for the device to complete this process.
When initialization is complete, the PWR LED will light up steadily, and the following
lights:
WAN, ENET will also light up depending on how the physical connection is
established.
2.
With all the data cables properly connected to the gateway device, user can observe the
front panel light status to determine the current device status. The table below shows the
possible indicator light statuses and their associated device statuses.
LED Status
PWR WAN ENET VOIP
LINE
Description
ON
At least one of
them is on
ON
Device is operating correctly; either WAN or LAN connection
is established.
ON BLINK
Firmware is not running correctly, and may need to be
downloaded again. When set up correctly, firmware
download and upgrade will occur automatically.
ON
At least one of
them is on
BLINK
BLINK
Firmware or configuration file is downloading from a network
server. Please do not turn off the device power during this
period.
ON
OFF
Out of service or boot code is not functioning properly.
Please power off and on the device again, and wait for about 3
minutes. If the LED status remains the same, please refer to
section on configuration for additional steps to take.
9.
If the VOIP LED is lit up steadily and VOIP calls can be made, stop here. If not, proceed
to the configuration steps below.
Note
The configuration information presented here will help the users set up their
gateway devices in the most commonly seen network environments. More detailed
configuration information will be presented in the chapter titled “Configuration
Using Web-Based Interface”.
