AXXIOM Manufacturing, Inc. SCHMIDT, Руководство по эксплуатации и обслуживанию

Страница: 32 / 60

32
© 2013 Axxiom Manufacturing, Inc.
6.1.6. Wire tie the twinline hose (#15) or electric deadman extension cords to the blast hose
assembly (#10).
6.1.7. Screw nozzle (#11) into the nozzle holder (#25) at end of the blast hose assembly (#10).
6.1.8. Connect the blast hose coupling (#26) to the threaded coupling (#27) on the abrasive
metering valve (#14). Then install safety pins (#39) and a hose whip check (#40) to
protect against accidental disconnections during operation. See Sections 5.11, and 8.7.
Failure to install safety pins on all blast hose couplings can result in hose disconnects
and could result in serious injury or death. See Sections 5.11 and 8.7.
6.1.9. Connect the twinline hose quick disconnects (#18 & #19) or the electric deadman
extension cord to the mating disconnects on the abrasive blaster piping (#16 & #17).
On multi-outlet blasters confirm connection will operate the corresponding blast outlet.
6.1.10. Connect a 150 psi rated (minimum) air supply hose to the air inlet crowfoot (#2) and
install safety pins (#39) and a hose whip check (#40) to protect against accidental
disconnections during operation. See Section 5.11 and 8.7.
Failure to install safety pins on all air hose couplings can result in hose disconnects and
could result in serious injury or death. See Section 5.11 and 8.7.
Figure 6.2 – Mini Abrasive Blaster with pneumatic blast controls