11
REV. 6/18/21
INSTAXPIO-JT1
• If power is required for the camera, the connection must be hardwired.
• This can be done at the radio using the
Red
wire for power, and the
Black
wire for ground.
• The
Black
Ground wire from the camera will have to be extended and routed to the front
with the video RCA.
Note:
Remove the glovebox to route the camera RCA to the dash.
If equipped with TPMS, and you wish to add the visual to the Pioneer Radio screen:
• Route the LD-CAN3T harness behind the glovebox and connect to the junction pictured
below. Any available spot can be used. If no spots are available, unplug one of the 2-pin
connectors and connect to the other end of the LD-CAN3T. This will connect to the LD-CH5-
PIO 2-Pin labeled “CAN 3”.
If you do NOT have the LD-CAN3T:
• Connect
Brown/White
from the LD-2PIN-CAN to one of the 2-pins
Yellow
wire, then
Brown
to the other wire in the 2-Pin. This will connect to the LD-CH5-PIO 2-Pin labeled “CAN 3”.
Brown/White
= CAN LOW
Brown
= CAN High
Note:
The glovebox must be removed to access this connection. Refer to photo for connection point.
USB REPLACEMENT & CAMERA INSTALLATION
