Axminster 107660, Оригинальное руководство пользователя

Страница: 8 / 36

MAIN ASSEMBLY
8
Locate the cast iron table (1), table alignment pin (21), the
four M8 x16mm bolts (24), M8x90mm bolt and nut (25),
M8 washers and spring washers (26-27).
Step 1 Locate the threaded bolt/nut (25), screw the nut
onto the thread then screw the bolt into the pre-drilled
hole in the bandsaw frame behind the tilt quadrant, see
fig 03.
Fig 03
Step 2 Remove the table insert and place safely aside, see
fig 04, lift the table (1), slide the blade through the table
slot, see fig 05, lower the table on to the tilt quadrant
assembly and line up threaded holes with the pre-drilled
holes in the tilt quadrant, see fig 06. Place a spring/washer
(26-27) over each M8 threaded bolt (24), see fig 07-08 and
secure the table in position using the supplied spanner
(22), see fig 09.
Fig 04
Fig 05
Fig 06
Fig 07-08-09
Step 3 Place a 90˚ square up against the blade and adjust
the table levelling stop bolt (25) beneath the table until
the table is perpendicular to the blade. Nip tighten the
nut on the stop to lock the setting, see figs 10-11-12.
Fig 10-11
25
Tilt quadrant
Levelling stop bolt
Table insert
1
24
26
27
22
90˚ Square