Axminster 107660, Оригинальное руководство пользователя

Страница: 23 / 36

SETTING UP THE SAW
23
Setting the Blade Guides (below table)
Beneath the table loosen the Hex screw (C) holding the
lower blade guide assembly in place and position so
that the leading edges of the side guide bearings are
approximately 2mm behind the gullets of the saw blade.
Re-tighten the Hex screw (C), see fig 66.
Note: The guide bearing should always be set behind
the teeth of the saw.
Fig 66
Fig 64-65
A
1
C
Rotate the top wheel by hand, at this point. None of the
bearings should come into contact with the blade-only
when in use. Adjust the lower blade guides, and set them
similarly to the upper guides, using a Hex key to release
and tighten the Hex screws. To adjust the lower thrust
bearing, loosen the Hex screw
(D) , see fig 66, turn the
adjusting knob (E) to move the thrust bearing
approximately 2mm behind the blade, see fig 67-68.
Re-tighten the Hex screw
(D)
, see fig 66. When all
adjustments have been made, recheck that when the
blade is pressed back against the thrust bearing, both
the upper and lower side guides are still behind the
teeth of the saw. When all adjustments are complete
re-connect the power, switch the saw on, allow to run
for several minutes, check that the blade is still tracking
correctly, there is no excessive vibration, etc. Switch off.
The saw is ready to be used.
Fig 67-68
D
E
2mm behind the blade
OPERATING INSTRUCTIONS
1. Make sure you have read and fully understood
the general instructions and safety precautions
that are printed in the preceding pages of this manual.
2. Before connecting the machine to the supply; check
the machine for obvious signs of damage, paying
particular attention to the plug and the power cable.
Rectify or have rectified any damage you discover. Check
that the blade you are using is the correct one for the job
in hand. Change the blade if necessary. Check the blade
is not damaged; is clean, sharp, tracks properly and is
correctly tensioned.
3. Set the upper blade guide to approximately 12mm
(1/2”) above the height of the work piece.
Continues Over....