Axminster 107660, Оригинальное руководство пользователя

Страница: 21 / 36

SETTING UP THE SAW
21
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Fig 52
Checking the table is square
Loosen the clamping handle beneath the table, clamp-
ing the tilt mechanism. Turn the tilt quadrant adjusting
handle until the table is hard against its stop. This is a bolt
with a lock nut screwed into the underside of the table,
see fig 53. The head of the bolt acts as a stop when it
strikes the machine frame. Tighten the clamping handle.
Fig 53
Make sure the upper blade
guide is raised as high as
possible. Place a square on
the table and move it up
against the blade (behind
the teeth), see fig 54.
Check that the blade is
perpendicular to the table.
If it is not, try resetting the
table. If it is still not correct,
loosen the table locking
handle, see figs 55 and
adjust the table stop bolt
nut until perpendicularity is
achieved, see fig 57. Fig 54
Fig 55-56
Fig 57
Make sure the table is up against the stop by turning
operating handle (A)
A
Tighten the lock nut and then re-check. When you are
satisfied that the table is set correctly, check that the
pointer of the tilt scale reads zero, if not, adjust it, see
fig 58. Retighten the table clamping handles.
Fig 58
Tilt quadrant clamping handle Motor locking handle
Levelling stop bolt
90˚ Square
Table stop bolt
Pointer
Scale
Continues Over....