Axminster 107660, Оригинальное руководство пользователя

Страница: 25 / 36

CHANGING THE SAW BLADE
25
MAKE SURE THE BLADE TEETH ARE
POINTING DOWN!
WARNING! BE VERY CAUTIOUS WHEN
YOU ‘UNFOLD’ THE BLADE; IT TENDS
TO ‘SPRING’ OPEN, BLADE AND TEETH
GOING EVERYWHERE.
Fig 71
Also check that the blade did not “unfold” inside out.
i.e. looking at the right side front of the loop, the teeth
should be on the front of the blade and pointing down.
If you can’t arrive at this view, turn the blade inside out
from its current position and look again.
Open up all blade guides so that they are clear of the
blade. Hold the blade approximately midway on either
side of the loop and feed it into the table slot. When you
get to the table insert cutout void, work the left side of
the loop into the slot in the guard in the neck of the
main saw frame. ‘Wriggle’ the right hand side of the blade
through the slot in the lower finger guard and through
the guard on the upper blade guide assembly, see figs
72-73-74.
Fig72
Fig 73-74
Lower finger guard
Quick release blade lever
Tension released
Ease the blade over the wheels and locate the blade in
the blade guides. Check that the blade is sitting
approximately in the middle of the wheels and re-tension
the blade by pushing the quick release lever forward.
Turn the top wheel by hand to ensure the blade will not
skip off the wheels and the blade is travelling in the blade
guides. When you are sure that the blade is “ON” and
stable, re-fit the table stabilising bolt and re-fit the table
insert. Loosen the upper blade guide clamp and set the
upper blade guide assembly so that the top of the blade
guide is level with the centre of the top drive wheel,
see fig 75. Re-tighten the clamp. Now carry out the
procedures as detailed in Setting up the saw.
Fig 75
Continues Over....
Blade guide