AXMINSTER WORKSHOP 108512, Руководство пользователя

Страница: 5 / 28

ASSEMBLY
5
Fig 03 Fig 04
Fitting the Bracket & Fence Assembly
Continues over...
Removing Machine from Pallet
Fitting the Feet
DO NOT LIFT BY THE TABLES - WHEN REMOVING THE MACHINE FROM THE PALLET
USE THE METHODS SHOWN BELOW!
1
2
3
I
C
NOTE: You will need to remove the motor drive guard housing to the rear of the planer thicknesser to
gain access to the inside of the machine. Loosen the three screws to each side of the housing assembly
and place safety to one side, see Image 1 & 2.
Undo and remove the four nuts holding the machine to the pallet. Locate the four feet (L), remove one of
the nuts on each foot and place safely aside. Insert the threaded feet up through the elongated holes to
each corner of the machines base and secure using the nuts you removed earlier, see Image 3.
L
D
Method 1: Put two substantial lengths of timber
(4”x2”) under the thicknesser table & either side
of the column. With assistance, lift both ends of the
timber up carefully & equally, then place the planer
down into its final position on a level floor or on to a
wheel base.
Method 2: On either side of the surface tables there
are two pre-drilled threaded holes. Screw a lifting
ring bolt (I) into one of these holes, repeat for the
opposite side. Attach lifting straps to the eye bolts
and using a lifting device, lift the machine clear of
the pallet and place the unit on a flat level surface.