AXMINSTER WORKSHOP 108512, Руководство пользователя

Страница: 12 / 28

GENERAL USE / OPERATION
12
• Place the workpiece onto the infeed table and
push up against the fence.
• Press the green start button, allow the machine
to run up to speed then advance the timber over
the cutter block. Maintain a steady feed speed and
constant downward pressure and side pressure
against the fence whilst feeding; ensure that fingers
are kept high up on the top of the timber. Make as
many passes as required to render the wood flat,
straight and square, 41-42.
Fig 41-42
Fig 43
• When you have finished, the cut press the red
stop button and let the machine run to a stop.
• You should now have 2 straight , clean, flat
surfaces that are square to each other, see fig 43.
Thicknessing
• Release the two table lock cam handles located
at either side of the machine (twist & pull), then
using the handle lift the tables up fully to a stop,
see fig 44-45-46. Swing over into place the yellow
guard/extraction hood, see fig 47.
• Measure the largest/thickest section of the timber
and set the thicknesser bed to this dimension
using the depth scale on the side of the machine. It
is perfectly ok to thickness the narrow edge of the
timber, a minimum of 20mm is recommended, see
fig 48.
Fig 44-45-46-47