AXMINSTER WORKSHOP 108512, Руководство пользователя

Страница: 15 / 28

MAINTENANCE / BLADE CHANGE
15
Daily -
•
Check that tables/beds are clean, not coated with resin etc. Apply a proprietary
cleaner/lubricating agent.
•
Check the cable and the plug for damage or defects. Mount the planer fence and check
it is set square.
•
Check the dust extraction hood and ensure there are no excessive build up of sawdust/resin,
especially in the mouth of the chip deflector and around the mouth of the extractor.
•
Check the blades for sharpness and damage.
Monthly - Carry out the above checks, plus
•
Remove the rear machine cover plate, check the condition and tension of the drive belt.
•
Check the auto-feed engage and disengage function.
•
Check the condition of the drive chains, clean and apply a light coating of oil to the chains
and sprockets. Apply a light oiling to all the bearing areas, taking care not to get oil on the tyre
surfaces. Replace the rear machine cover plate.
•
If the table lock downs become ‘slack’ they can be adjusted by altering the height of the table
lock stud. Hold the stud firmly and loosen the lock nut.
Weekly - Carry out the above checks, plus
•
Clean the machine thoroughly; remove any shavings, sawdust, chips etc,
from in, under and around the machine.
•
Check the cutter block for resin build up, especially behind the blade and in
the scallop of the chipbreaker/wedge.
•
Check that the infeed roller is free of debris & resin build up.
•
Lift the tables and brush out and clean any debris or build up around the
cutter block & feed rollers
•
Check the action of the anti-kickback fingers, again clean and lubricate as required.
Continues over...
Blade Rotation/Change -
The spiral cutter block has four rows of durable
solid carbide square cutters running around its
circumference. There are 44 square cutters in total
on the 260mm model and 56 cutters on the 310mm
model and after many hours of use these cutters will
need rotating.
DISCONNECT THE MACHINE FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
•
Brush all debris from the cutter/cutters
that are to be rotated or changed.
•
Using only the tool provided undo the
countersink torx screw, see fig 54.
•
Lift & twist the carbide cutter so that the
fresh sharp edge faces the infeed table
direction, ensuring that there is no debris
under the cutter, see fig 54
•
Retighten the countersink torx screw &
repeat if numerous cutters seem blunt or
damaged.
•
NB - Each cutter has a rotation marker to
help you monitor which edges have been
used, see fig 55.