Axminster Trade AT260PT, Оригинальное руководство пользователя

Страница: 31 / 60

Maintenance
31
Daily
Check the overhand tables and the thicknessing table are
clean, not coated with resin etc. Apply a proprietary
cleaner/lubricating agent such as ‘Liberon Wax & Polish
Remover’ (1) and ‘Liberon Lubricating Wax’ (2).
Check the cable and the plug for damage or defects.
Mount the planer fence and check it is set upright.
Check the dust extraction hood and ensure there are no
excessive build ups of sawdust/resin, especially in the mouth
of the chip deflector and around the mouth of the extractor.
Check the blades for sharpness and damage.
Check the rollers of the thicknessing table rotate freely,
and there is no build up between the roller and the
extension table.
Weekly
Carry out the ’Daily’ checks.
Clean the machine thoroughly, remove any shavings, sawdust,
chips etc, from in, under and around the machine.
Check the cutter block for resin build up, especially behind the
blade and in the scallop of the blade holder.
Raise the tables and brush out and clean any debris or build up
around the area of the noise attenuating slots in the edges of
the overhand tables.
Check the infeed and take off pressure rollers are not clogged,
clean as necessary.
Check the action of the anti-kickback fingers, again clean and
lubricate as required.
DISCONNECT THE MACHINE FROM THE MAINS
SUPPLY BEFORE CONTINUING!
Monthly
Carry out the ‘Weekly’ checks.
Remove the upper and lower machine cover plates, check
the condition and tension of the drive belt.
Check the autofeed engage and disengage function.
Chip deflector
Drive roller
Pressure roller
Dust extractor
Blade
Anti-kickback fingers
1 2
3
Continues Over....