Axminster Trade AT260PT, Оригинальное руководство пользователя

Страница: 22 / 60

Setting up the Machine
22
Infeed Surface Table
1. Raise the infeed table by turning the rise and fall adjusting
knob, see fig 34, until the infeed table pointer reads ‘zero’ on the
scale, see fig 35.
2. Place a straight edge across both tables and check they are
both level, see fig 36. If not, adjust the two positioning studs
below the table, see next step.
Fig 34-35-36
Scale
Infeed table adjusting knob
3. Remove the fence assembly and lower the unit onto the
storage brackets to the rear of the machine. Unlock the infeed
table locking handle and raise the table up, see fig 37-38-39.
With the table out of the way adjust the two positioning studs,
see fig 40.
NOTE: Remember to make small adjustments to the studs
so you don’t over correct.
4. While holding the table, pull out the table locking bar and
lower the infeed table, secure in place with the locking handle,
see fig 41-42. Place the straight edge across the tables and
check again. Repeat the procedure until both surface tables
are level.
Fig 37-38-39
Fig 40
Straight edge
Table positioning studs
Locking nut
Fig 41-42
Table locking bar
Infeed surface table
Pointer