Axminster Trade 106202, Оригинальное руководство пользователя

Страница: 18 / 28

Maintenance
18
Check the condition and tension of the drive belt, see fig 33.
Check the autofeed engage and disengage function, see fig
34-35.
Check the condition of the drive chains, clean and apply
a light coating of oil to the chains and sprockets.
Using ‘Dry PTFE Film Antistick’ spray, (3) lubricate all the bear-
ing areas, taking care not to get oil on the drive belt and tyre
surfaces. Replace the motor/drive access panel.
Fig 31-32
Un-lock
Fig 33
Drive chain
Drive belt
Sprockets
Fig 34-35
Drive Belt Tension
Remove the motor/drive access panel, if not done so already.
Check the tension of the belt by pushing the belt, there should
be a deflection of between (12-20mm). If there is considerable
movement in the belt, adjust the motor’s threaded pivot stop.
Fig 36-37
Autofeed wheel disengaged Autofeed wheel engaged
Autofeed assembly
Autofeed wheel
Drive shaft
To adjust the threaded stop first loosen the motor’s pivot bolt
(A) on the motor’s base plate then adjust the threaded stop
nuts (B and C) until the drive belt is under tension. Nip up the
pivot bolt (A), see fig 36-37.
Motor base plate Threaded pivot stop
B
C
A
Autofeed wheel