Axminster Trade 106202, Оригинальное руководство пользователя

Страница: 13 / 28

Positioning the Machine
13
Ascertain the orientation of the machine and move it to its
desired position in the workshop. Ensure that the machine is
positioned to allow sufficient clearance all round to cater for
the maximum length of timber you wish to machine. The
thicknesser should be positioned on a flat level surface.
Setting the Digital Thickness Display
Allow sufficient
clearance all round
the machine
The Axminster Digital Display will give an accurate visual
indication of the amount you are adjusting the thicknessing
table in 0.10mm increments. Perfect for multiple board
production.
To set the ‘Digital Display’, follow the instruction below:
1. Roughly by eye set the distance between the thicknessing
table and the blade at its lowest point.
CONNECT THE THICKNESSER TO THE
MAINS SUPPLY AND SWITCH ON!
SWITCH OFF THE THICKNESSER
AND WAIT UNTIL IT COMES TO A
COMPLETE STOP!
2. Carefully insert a piece of timber through by eye.
3. Raise the table in 1mm increments and take further cuts
until you have a clean cut.
4. Without raising the table, turn the timber over and repeat
the process.
5. Remove the timber from the table and accurately measure
the machined sides using a vernier and write down the
reading, see fig 07.
6. Loosen the collar on the digital thickness display, see fig 08.
Turn the collar to dial in the measurement you wrote down,
see fig 09. Re-tighten the collar to the drive shaft.
Fig 07
Fig 08-09