Axminster Trade 106202, Оригинальное руководство пользователя

Страница: 15 / 28

Operating Instructions
15
Fig 17
DISCONNECT THE MACHINE TO THE MAINS
SUPPLY BEFORE MAKING ANY ADJUSTMENTS!
Emergency Stop
The emergency stop is a mushroom shaped button, mounted
to the side of the thicknesser, below the thicknessing fuction
lever. In an emergency, press the button in to bring the machine
to a halt. Twist the button to unlock before restarting the
thicknesser, see fig 18-19.
Fig 18-19
Un-Lock
Changing the Spiral Cutter Block Blades
DISCONNECT THE MACHINE FROM THE MAINS
SUPPLY BEFORE CONTINUING!
The spiral cutter block has four rows of square cutters running
around its circumference. There are 84 square cutters in total on
the 12inch cutter block. There is a blade machined to each side
of the square cutter allowing the cutter to be rotated to a clean
sharp edge if one side has been damaged or has become blunt,
see fig 20.
The square cutter has an embossed position marker to one
of its four corners, once this mark has gone round one full
rotatation it is time to replace the square cutter, see fig 21.
To rotate the cutter, loosen the Torx head screw and rotate until
the new edge is in alignment with the other cutters. Re-tighten
the Torx head screw to lock the cutter in place, see fig 21.
Position marker
WARNING! BE VERY CAREFUL WHEN
TURNING THE CUTTERS AS THE
BLADES ARE EXTREMELY SHARP.
DO NOT OVERTIGHTEN TO AVOID THE TORX
HEAD SCREW HEAD FROM GETTING
DAMAGED!
Fig 20-21
Torx head screw
Blade edge