AXIS Q1635-E Fixed Network Camera
Video and Audio
Basic
Follow the on-screen instructions on the
Basic
tab to adjust zoom and focus. The pixel counter is used to determine the number of
pixels in an area of the image, for example to ensure that the image size fulfills specific requirements. To position the pixel counter,
click on the text and drag the window to the desired position.
Note
• The back focus (step 2) should only be reset if the camera has been focused previously.
• Set focus as precisely as possible using the focus puller on the lens (step 3) before starting the automatic fine-tuning (step 4).
• If the camera is placed so that it is difficult to look at the image and move the pullers at the same time, you can use the
Focus Assistant to focus the camera; for instructions, see the Installation Guide supplied with the product.
Advanced
The tools on this page can be used to find the optimal focus position. Always open the iris before focusing and enable it when finished
focusing. Focus is measured in the part of the image covered by the
Focus window
. Use the mouse to move and resize the window
and then click
Fine-tune focus automatically
. If needed, click in the
Focus position
bar or on the arrows at the ends of the bar, to
further adjust the focus. The buttons < and > move the focus position one step in either direction. The buttons << and >> move the
focus position multiple steps in either direction. Clicking on the bar sets focus to that position.
If the camera is not focused after completing the above instructions, try the
Full ranoe focus scan
. The scan, which can take
several minutes, transforms the focus position bar to a graph where peaks indicate the best focus positions. Click in the graph
to set focus to the desired position.
Set Up Audio
To change the product’s audio settings, go to
Video & Audio > Audio Settinos
.
To include the audio stream in a video stream, go to
Video & Audio > Video Stream
. Under the
Audio
tab, select
Enable audio
.
Each stream profile is a separate video stream. To include the audio stream in all stream profiles, go to the audio tab in each stream
profile settings page and enable audio. For more information, see
.
If you have enabled view areas, remember that each view area is a separate video stream. To include the audio stream in all view
areas, go to the audio tab in each video stream page and enable audio. For more information see
.
Audio Modes
The Axis product supports the following audio modes:
•
Full duplex –
Simultaneous two-way audio allowing the Axis product to transmit and receive audio at the same time.
There is no echo cancellation; if feedback loops appear, try moving the microphone or the speaker.
•
Half-duplex –
Audio can be transmitted to and from the Axis product but only in one direction at a time. To transmit
audio using the Live View page, use the
Talk
and
Listen
buttons, see
.
•
Simplex – Network Camera speaker only -
Audio is transmitted from a client to the Axis product and can be played by
a speaker connected to the product. To transmit audio using the Live View page, the
Talk
and
Microphone on
buttons
must both be active, see
•
Simplex – Network Camera microphone only -
Audio captured by the product microphone is transmitted from the
Axis product to one or more clients.
To set the audio mode, go to
Video & Audio > Audio Settinos
and select the desired mode from the
Audio mode
drop-down list.
Audio Input
An external microphone or a line source can be connected to the Audio-in connector. Configure the audio input settings under
Video
& Audio
>
Audio Settinos
.
31
