AXIS Q1635-E Fixed Network Camera
System Options
•
Generic HTTP
allows the Axis product to receive data and send commands via HTTP.
•
Pan Tilt Zoom
is used to control a PTZ device. The PTZ device requires a driver. See
for more information.
Drivers can be downloaded from www.axis.com
•
Generic TCP/IP
allows the Axis product to receive data and send commands via TCP/IP.
Select the desired
Port Type
from the drop-down list. For more information, see the online help
.
Port Status
The list on the
System Options > Ports & Devices > Port Status
page shows the status of the product’s input and output ports.
Accelerometer
Tilt anole
indicates the angle to which the camera’s lens holder is tilted. A 0° tilt is when the camera is pointing to the ground. It’s
possible to have a tilt angle between 0 and 180°. To tilt to 180°, tilt to an angle of 90°, rotate the lens holder and tilt to a further 90°.
Rotation anole
indicates the angle to which the camera’s lens holder is rotated. The rotation range is between 0 to 360°. The camera
is considered to be in a level position when the rotation angle is 0°, 90°, 360° or 270°.
The leveling assistant that helps to level the camera is enabled by default. To disable it, de-select the
Enable levelino assistant
option
from
System Options
>
Ports & Devices
>
Accelerometer
and click
Save
. To refresh the page and view the saved setting, click
Reset
.
Maintenance
The Axis product provides several maintenance functions. These are available under
System Options > Maintenance
.
Click
Restart
to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Note
A restart clears all entries in the Server Report.
Click
Restore
to reset most settings to the factory default values. The following settings are not affected:
•
the boot protocol (DHCP or static)
•
the static IP address
•
the default router
•
the subnet mask
•
the system time
•
the IEEE 802.1X settings
•
the focus position
•
uploaded applications are kept but must be restarted
Click
Default
to reset all settings, including the IP address, to the factory default values. This button should be used with caution. The
Axis product can also be reset to factory default using the control button, see
Reset to Factory Defailt Settings on page 69
.
To identify the product or test the Status LED, click
Flash LED
under
Identify
and specify the duration in seconds, minutes or hours.
This can be useful for identifying the product among other products installed in the same location.
For information about firmware upgrade, see
Upgrade the Firmware on page 70
.
67
