15
Special Features
Battery Voltage Check (NEXT 0)
The relative voltage of the main processor batteries may be checked during operation of the micro5. This
will give you an idea of how much power is left in the batteries. To check the batteries do the following.
While the instrument is operating, press the NEXT key followed by 0 on the numerical key pad. In the probe
display area you will see a three number display. This is the voltage of the processor batteries. This display
will only stay on for about 1.5 seconds. For instance a reading of 300 is actually 3.0 volts. It is important to
check the voltage only during treat ment. This will put a load on the batteries and give a truer reading. At rest
readings may be falsely high. Readings of 3.5v and above indicate a good reserve. At 3.0 and below the bat-
teries should be recharged as soon as possible.
Continuous Operation (NEXT 1)
Pressing the NEXT key followed by 1 on the numerical key pad allows continuous operation of the micro5
regardless of the time indicated on the timer. The instrument will continue to operate but the timer will not
count down. The instrument will remain in the continuous mode until NEXT, 1 is pressed again or until the
instrument is turned off by the On/Off switch on the back of the unit.
Display Current (NEXT 2)
This feature is used to display the relative output of channel one, measured in micro amps. This feature is
used by the factory for diagnostic purposes.
Disable Tone During Current Failure ( NEXT 3)
Should Factory determine that the failure of a m5 to pass the current test is a false failure, the current test
warning tones can be turned off until the device can be returned to us for repair. This will allow the use of
the device without the tones being heard.
NEXT 4,5,6 ARE FOR factory USE ONLY. SHOULD YOU PRESS NEXT AND THEN EITHER 4,5 OR
6, TURN OFF THE DEVICE AND TURN BACK ON. THIS WILL RESET THE DEVICE TO ORIGINAL
SETTINGS.
Increase/Decrease Probe Sensitivity (NEXT 7, NEXT 8)
By pressing NEXT 7 and then a 2 digit number, you will increase the probe sensitivity by the percent of the
2 digit number you entered. For example: Pressing NEXT 7 and then 5-0,will increase the sensitivity by
50%. You must be in the probe mode for this to have an effect. To reset, leave the probe mode and then re-
enter the probe mode. To decrease the probe sensitivity, press NEXT 8 and then enter a 2 digit number. This
time the sensitivity will decrease by the percentage of the 2 digit number.
