AXIOMTEK SBC81872, Руководство пользователя

Страница: 15 / 73

SBC81872 Socket479 All-in-One CPU Card Series User’s Manual
Installation
9
C h a p t e r 3
Installation
This chapter describes the hardware installation procedures on
the
SBC81872 all-in-one Socket479 CPU card. The following is
a list of typical peripherals required to build a minimum system:
„
Power supply and passive backplane
„
IBM
™
PC/AT keyboard
„
Display monitor
„
Floppy or hard disk with MS-DOS or Flash Disk emulator
3.1 System Memory
The SBC81872 industrial CPU card supports two 184-pin DDR
sockets for a maximum total memory up to 2GB.
3.2 CPU Installation
1.Using the method shown in Figure 1, place the new
processor Into the socket. Align the processor ’ s pin A1 with
the arrow on the micro-FCPGA socket. The pin A1 of the
processor is identified with an embroidered corner and pin
A1of socket is turn the actuator until The processor drops
completely in.
Note: You should not have to press down the processor. If the
processor doesn
’ t drop completely into the socket, turn the
actuator until the processor drops completely in.