that may damage your meter. Note - indentifies symbols from which you can understand operation and features of your
meter. For related international symbols used by the Meter and the Manual, please read table below for reference.
Warning
•
Do not use the meter if it is damaged. Before using the meter, inspect the case. Look for cracks or missing plastic.
Pay particular attention to the insulation surrounding the connectors.
•
Make sure the battery door is closed and latched before operating the meter.
•
Do not use the meter if it operates abnormally. Protection may be impaired. When in doubt, have the meter serviced.
•
Do not operate the meter around explosive gas, vap or, or dust.
•
Use only type AA batteries, properly installed in the meter case to power the meter.
•
Use caution when working above 30V AC RMS, 42V AC PK, or 60V DC. Such voltages pose a shock hazard.
•
When using the probes, keep fingers behind the finger guards on the probes.
•
Connecting the common test lead before connecting the live test lead. When disconnecting test leads, disconnect the
live test lead first.
•
Read carefully and make sure well understanding of this Manual before use.
•
Make sure the requirements in the Manual are strictly followed and keep the Manual for reference whenever needs.
•
Mis-operation may cause accidents and damages to the Meter in testing.
Caution!
To avoid possible damage to the Meter or to equipment under test:
•
Make sure the rotary switch is in the right position, disconnect the testing leads and the circuit under test before
rotating, conversion in testing is prohibited in case of damaging the Meter.
•
Cut all the power off and release electricity fully from all capacitor before testing online resistance, diode and
continuity.
•
Check fuse in the Meter before testing current. Cut off the power before connection. Remember: when testing current,
connect the Meter with the Circuit in series. Do not connect testing leads to any circuit in parallel.
•
Do not use the Meter if symbol ” ” displays.
•
Do not store or use the Meter in high temperature, high moisture, explosive, inflammable, strong electromagnetic
environment and dew or direct sunlight place.
•
Do not use abrasive or solvent to clean the Meter, use a damp cloth or neutral detergent instead.
•
Make dry before store if the Meter is damp.
1.4. Symbols
AC Current
DC Current
AC or DC
Low Battery
Conforms to Standards of European Union
Earth ground
Double Insulated
