AXIOMATIC LIN - J1939 CAN, Руководство пользователя

Страница: 13 / 82

UMAX140610. LIN
– J1939 CAN Protocol Converter with PWM Output. Version 1
Page: 13-81
3.2 PWM Output
Table 4. PWM Output Function Block Configuration Parameters
Name Default Value Range Description
Output Type 1, Digital PWM Drop List See Table 5.
Output at Minimum
Command 0.00 Depends on
Output
Type Digital PWM:
Digital Mixed PWM and Frequency:
[0…100] %DC
Digital Frequency: [0.1…20000] Hz
Digital ON/OFF: [0…1]
Output at Maximum
Command 100.00
Depends on
Output
Type
Ramp Up (Min to
Max) 0ms 0 to 10,000 Unit in milliseconds
Ramp Down (Max to
Min) 0ms 0 to 10,000 Unit in milliseconds
Fixed Frequency/Duty
Cycle 500Hz Depends on
Output
Type Default values depend on output
type.
Digital Control
Response 0, Normal Logic Drop List Only configurable when output type
is set to Digital ON/OFF. See Table
6.
Digital Blink Rate 500ms 100 to
5,000 Only configurable when control
response is set to Blink Logic.
Digital Type VPS
Range 0, 0V to 6V Drop List 0 = 0V to 6V
1 = 0V to 13V
Control Source 1, CAN Receive
Messages Drop List See Table 8.
Control Number 1, CAN Receive
Messages #1 Per Source See Table 8.
Control Response 1, Off Below Control
Minimum Drop List See Table 9.
Enable Source 0, Control Not Used Drop List See Table 8.
Enable Number N/A Per Source See Table 8.
Enable Response N/A Drop List See Table 10.
Override Source 0, Control Not Used Drop List See Table 8.
Override Number N/A Per Source See Table 8.
Override Response N/A Drop List See Table 11.
Output at Override
Command 1V Depends on
Output
Type Same as minimum and maximum
command
Fault Response 1, Output Fault
Mode Value Drop List See Table 12.
Output at Fault
Command 0V Depends on
Output
Type Same as minimum and maximum
command
Fault Detection is
Enabled True False or
True See Section 3.2.4 and 3.9
Event Generates a
DTC in DM1 False False or
True See Section 3.2.4 and 3.9
Event Cleared Only
by DM11 False False or
True See Section 3.2.4 and 3.9