Axia xSelector, Инструкция по установке и эксплуатации

Страница: 23 / 57

2: U
si
ng x
S
el
ec
to
r •
15
IP Address Page
This page item is similar to the Node ID page. It’s primarily for manual setup if preferred.
Fig. 2-4: IP Address page.
On the right side of the screen are, again, the two icons.
• The top icon (two boxes) represents the page change function triggered by a tap of the encoder (advance to
next page).
• The bottom pencil icon denotes an “edit” function for this page; press and hold the encoder knob for 10
seconds to enter Edit mode.
From the Edit view, the user can edit several settings.
• Once in Edit view, you’ll see a cursor under the IP Address digits. Rotate the encoder knob to change the
value of the digit; press the encoder to move to the next digit.
• Move through the Network Mask field in the same way to make changes.
• The next option allows you to select the active Livewire port manually; useful if the dual ports are config-
ured for Failover operation.
• The last option from this menu is the “Volume” selection:
»
Choose “Phones” if you only want the front-panel Volume knob to control the headphone-jack out-
put.
»
Choose “HP&Out” for the Volume knob to control the output of both the headphone jack and rear-
panel outputs.