Axema Unitel DI-623-21L, Инструкция по установке и эксплуатации

Страница: 5 / 16

AXCALL
3
A separate button connected to terminal PL1:6 could even activate memory address
101 to get you in touch with the reception.
Note! If the red LED starts flashing when you make a call, you have forgotten to
connect the telephone line or the line is occupied.
It’s also possible to make a call to the entrance. Dial the number and the intercom
answers automatically and you can talk to the visitor. This function is disabled by
putting the jumper in OFF-position (see page 10). As delivered the jumper is normally
in OFF-position.
Note: If more intercoms are connected to the same telephone line, the jumper must be
in OFF-position.
2. INITIALISATION AND PASSWORD
After installation the unit has to be initialised with a special code. This code pre-sets
printer parameters, clears the memory
including the password sets the opening time
to 7 sec. and sets the time of call to 60 sec. The code is 199200.
INITIALISATION AND MEMORY RESET
- Open the door unit.
- Press and release
RST -button on the circuit board and wait for four short
beep.
- Enter 199200 .
- Press #. 6 short signals are heard. Note: The memory is cleared!
To be able to program the unit and to get information out from it you do need a
password. This password is a six-digit code.
SET PASSWORD
- Press and release RST -button on the circuit board and wait for four short
beep.
- Enter a 6-digit code .
- Press # and you hear two short and one long. Your password is set.
- Press * and close the door unit.
The following codes are not permitted: 00 00 00, 19 92 00 - 19 92 99 You can nei-
ther use a password which contains a telephone number you are going to use.