Axcera INNOVATOR, Инструкция по эксплуатации

Страница: 59 / 121

UHF Analog Driver/Transmitter/ Chapter 3, Site Considerations,
Translator Installation and Setup Procedures
LX Series, Rev. 3 3-21
Table 3-39: Menu 40-15 - Transmitter Set-up: Auto Stand-By Control
Certain LX transmitter locations are required to reduce to no output power on the loss of
video input. When a LX transmitter is configured for Auto Stand-By On Modulation Loss,
the transmitter will switch to stand-by, if a modulated input signal fault is detected by the
IF Processor module that lasts for more than ten seconds. Once the modulated input
signal fault is cleared, a transmitter in operate mode will return to normal operation. This
feature is implemented in transmitter software version 1.4 and above.
Table 3-40: Menu 40-16 - Transmitter Set-up: Receiver ALC Fault Set Up
T R A N S M I T T E R S E T - U P
1 1 R E C E I V E R
A L C S E T
F A U L T A T 2 . 5 0 V D C
↓ ↑
( + ) E S C ( - )
This screen is used to set up the level of the ALC at which the Receiver will fault. This
feature is implemented in transmitter software version 2.0 and above.
NOTE: The above
screen will only be present if a Receiver is part of the system.
Table 3-41: Menu 40-17 - Transmitter Set-up: Inner Loop Gain Control
This screen is used to set up the Inner Loop Gain of the exciter/amplifier assembly. This
feature is implemented in transmitter software version 2.0 and above
Table 3-42: Menu 40-18 - Transmitter Set-up: Optional System Control
This screen is used to set up any optional system, including the addition of the optional
Modulator in a translator system. This feature is implemented in transmitter software
version 2.0 and above.