Axcera INNOVATOR, Инструкция по эксплуатации

Страница: 52 / 121

UHF Analog Driver/Transmitter/ Chapter 3, Site Considerations,
Translator Installation and Setup Procedures
LX Series, Rev. 3 3-14
Table 3-17: Menu 11 - Error List Access Screen
This screen of the transmitter shows the current number of errors, displayed in upper,
right of screen (0), and provides operator access to view Menu 20, the error list screens,
by pushing the ENT button. When ENT is pushed, Menu 20, the Error List Display Screen
is displayed. If the
↓
key is pushed the display changes to Menu 12, Table 3-18, the
Transmitter Device Data Access Screen. If the
↑
key is activated the display returns to
Menu 10, the Main Screen.
Table 3-18: Menu 12 - Transmitter Device Data Access Screen
This screen of the transmitter allows access to various parameters of the transmitter
system. This is the entry point to Menu 30, the System Details Screens, by pausing the
ENT button. When the ENT button is pushed, Menu 30 is accessed. Go to Menu 30, Table
3-23 for set up details. Before pushing the ENT button: if the
↓ key is activated the
display changes to Menu 13, Transmitter Configurations Access Screen. If the
↑
key is
activated the display returns to Menu 11, the Error List Access Screen.
Table 3-19: Menu 13 - Transmitter Configuration Access Screen
This screen of the transmitter allows access to various software settings of the
transmitter system. If ENT is pushed, go to Menu 40, Table 3-24, the access to
transmitter configuration and set up. Before pushing the ENT button: if the
↓
key is
activated the display returns to Menu 10, Main Screen. If the
↑
key is activated the
display returns to Menu 12, the Transmitter Device Data Access Screen.
Table 3-20: Menu 20 - Error List Display Screen
This screen of the transmitter allows access to the system faults screens. Fault logging is
stored in non-volatile memory. The transmitter's operating state can not be changed in
this screen. The 'CLR' switch is used to clear previously detected faults that are no
longer active. The
↑
key and
↓
key allow an operator to scroll through the list of errors
that have occurred. The ESC button is used to leave this screen and return to Menu 11,
Table 3-17, the Error List Access Screen.
NOTE: Shown is example of a typical screen.