AWT PIM-P, Руководство пользователя, Страница: 7 / 110

2-2
PIM-P Analyzer User’s Manual
Copyright AWT-Global, LLC. All rights reserved.
2.1 SYMBOLS
This safety requirement symbol (located on the rear panel) has been adopted by
the International Electro-technical Commission, Document 66 (Central Office) 3,
Paragraph 5.3, which directs that an instrument be so labeled if, for the correct use
of the instrument, it is necessary to refer to the instruction manual. In this case it is
recommended that reference be made to the instruction manual when connecting the
instrument to the proper power source. Verify that the correct fuse is installed for
the power available.
The CAUTION symbol denotes a hazard. It calls attention to an operational
procedure, practice or instruction that, if not followed, could result in damage to or
destruction of part or all of the instrument and accessories. Do not proceed beyond a
CAUTION symbol until its conditions are fully understood and met.
The NOTE symbol is used to mark information which should be read. This
information may be very useful to the operation when with the subject covered in
this section.
The HINT symbol is used to identify additional comments which are outside of
the normal format of the manual, however can give the user additional information
about the subject.
The following general safety precautions must be observed during all phases of
operation and maintenance of the AWT PIM-P Passive Intermodulation Analyzer. Failure
to comply with these precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended use of the instrument. AWT
assumes no liability for the customer’s failure to comply with these requirements.
INSTRUMENT MUST BE GROUNDED
To minimize shock hazard, the instrument chassis and cabinet must be
connected to an electrical ground. The instrument is equipped with a three
conductor, three prong AC power cable. The power cable must either be
plugged into an approved three-contact electrical outlet or used with a
three-contact to a two-contact adapter with the (green) grounding wire
firmly connected to an electrical ground at the power outlet.
DO NOT OPERATE THE INSTRUMENT IN AN EXPLOSIVE
ATMOSPHERE
Do not operate the instrument in the presence of flammable gases or
fumes.