Awoco RH-WQ Island Mounted Series, Руководство пользователя

Страница: 7 / 16

7
Venting System Setup:
• This range hood is 6" top venting through the
roof or wall.
• Always use 6" round rigid or semi-rigid type
metal/aluminum ducts to maximize airflow.
• Observe and determind the location for the
venting route from the hood to the outdoors.
• A straight, short vent run will allow the hood to
perform more efficiently.
• Fasten all connections with sheet metal screws
and tape all joints with certified Silver Tape or
Duct Tape.
• Use caulking to seal the roof or wall opening
around the cap.
Vertical Venting Roof Exhaust
Horizontal Venting Wall Exhaust
Measure and estimate the following figures
before installation:
• The distance between the countertop / stove to
the bottom of the range hood.
• The height of hood and duct.
IMPORTANT!
• Use the Duct Run Calculation Chart to
calculate the total available duct run when using
elbows, transitions and caps.
• Always keep the number of transitions and turns
minimum.
• If long duct run is needed, increase the duct size
from 6" to 7" or 8".
• If a reducer is needed, use a long reducer
instead of a pancake reducer and install it as far
away from the range hood as possible. Reducing
the duct size will restrict and decrease the speed
of the airflow and hense lower the range hood's
performance.
• If transitions or turns are needed, install them as
far away from the range hood as possible and
keep the distance between the 2 as far apart as
possible.
INSTALLATION PREPARATIONS
Range Hood
Roof Cap
Range Hood
Extension
Covers
Min. 24", Max. 30".
Recommended 27"
Stove Top
Roof
Ceiling
Side Wall Cap
Ceiling