AWE MODELS II, Быстрый старт

Страница: 11 / 15

- Page - 11 -
ADVANCED WATER ENGINEERING, INC.
Indian Harbour Beach, FL
www.advancedwater.com
STEP 3
Air gap and drain faucet connections :
A. Run 1/4” red air gap and 3/8” red drain tubing up through hole in counter.
B. Hold faucet over mounting. hole.
C. Press 1/4” red Air gap tubing firmly over the ¼” Barbed Connector on faucet.
D. Press 3/8” tubing over the 3/8” Barbed Connector on the faucet.
E. Lower faucet into mounting hole
NOTE: FOR PROPER FIT, CUT POLY TUBING
SQUARE, NOT AT AN ANGLE (Refer to Sec. 6)
STEP 4
Install Faucet assembly in mounting hole:
A. Position faucet through hole in countertop with front in desired position.
B. Position Retainer Plate, Spacer, Washer and
Star
washer, over base screw and thread hex
nut onto base screw and tighten.
C. Place Compression Hex Nut, Compression Sleeve and insert onto the 1/4” Blue Product
Water Supply plastic tubing.
D. Insert tubing into Base Screw and use wrench to tighten Compression Hex Nut.
NOTE: BE CAREFUL NOT TO OVERTIGHTEN