Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE. All rights reserved. Rev 1.3
Install your AWE tip outlet section (
C17
), onto
the AWE single exit tube (
E30
) as shown in
Figure 9.
Ensure the C17 is parallel with the body line of
the bumper.
The C17 tip merge is symmetrical so top
versus bottom orientation does not
matter.
Install your AWE single exit tube (
E30
), place a
clamp on the up turned end of the AWE
overaxle inlet tube (
E26
) shown at (
A
) in
Figure 8
.
Bottom out the slip joint, then slide the hanger
bar into the factory hanger, as shown at (
A
) in
Figure 8.
STEPS 8
-
13 ARE FOR SINGLE EXIT SYSTEMS ONLY
To install the exhaust tips with integrated
clamps, first, attach the exhaust tip in the
proper orientation onto the exhaust outlet tube.
Insert one of the carriage bolts from the
hardware kit
(3910
-
41010)
through the tab on
the exhaust tip and thread on one of the
corresponding nuts.
Using anti
-
seize on the bolt threads will help
installation and prevent breakage of hardware.
This exhaust system only has 2 exhaust
tips while the integrated clamp kit has
enough hardware for our 4 tip exhaust systems.
You will have 2 sets of hardware left over that
will not be used.
