Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE. All rights reserved. Rev 1.3
Install your AWE driver side tailpipe (
E28
), start by sliding a provided clamp onto the tailpipe.
Next insert the hanger bar into the OE hanger as shown at (
A
) in
Figure 22
-
1.
Now bottom out the
slip joint on the overaxle tri
-
section (
E27
), as shown at (
B
) in
Figure 22
-
2
.
Note:
Snug the clamp on the joint at this time, but do not fully tighten it.
Install your AWE overaxle tri
-
section (
E27
).
You want to make sure the driver
’
s side leg (
A
)
is parallel with the bed of the truck, as shown in
Figure 21
.
STEPS 21
-
28 ARE FOR QUAD EXIT SYSTEMS ONLY