Avtek Soundbar, Руководство пользователя

Страница: 11 / 19

11
Power Supply
•
Verify that the operating voltage of the device
is compatible with the power source.
•
Disconnect the power supply and an external
antenna from wall sockets if there is a
lightning storm is likely.
•
Disconnect the power supply if no is going to
be present in the room, or if the device is not
going to be used for a long time.
•
Protect the power cord from physical damage.
•
Use the power cord included with the device
and do not modify or extend it.
•
Make sure the mains socket the device is
connected is properly grounded.
Temperature
•
Do not place the device near a heater or above
it.
•
If the device has been moved from a cold
environment to a warm one, disconnect the
device from power socket and leave it for at
least 2 hours to make sure any moisture that
could condensate inside the device has
evaporated.
•
The optimum ambient temperature for
operation of the device is 0°C – 40°C.
Humidity
•
Do not expose the device to rain or drizzle or
place it near water.
•
Use in a dry and cool place. The optimum
humidity for the device operation is 10 - 90%.
Ventilation
•
Never block ventilation openings.
•
Make sure there is enough space for
ventilation around the device: 10 cm on the
left, right and in the rear and 20 centimetres
above the device.
Headphones
•
Extended use of headphones at high-volume
may damage your hearing.
•
Before using headphones make sure to reduce
the volume.
Battery
•
End-of-life batteries must be disposed of
properly.
•
Keep batteries away from children at all times.
Do not expose batteries to fire.
Maintenance
•
The device can be repaired or maintained only
by authorised service staff.
3.
Product set contents
1 soundbar
1 power supply unit
7
1 remote control
1 CR2025 3V battery (installed)
1 stereo RCA (cinch) cable
8
2 screws 28
2 rawlplugs 29
1 drilling template 30
1 operating manual
4. Before first use
• Remove all packing material.
• Check that the device shows no signs of
damage.
4.1 Remote control
Putting soundbar to operation
• Remove the insulating strip from the remote
control battery compartment.
Battery replacement
DANGER OF EXPLOSION!
If the battery is not installed correctly, it may
explode!
Replace the battery only with the same or
equivalent type.
1.
FIG. A: Remove the battery compartment cover.
To do this, unlock and slide the cover in the
direction shown by the arrow.
2. Replace the old battery with a new one.
WARNING! While installing the battery, make sure
the correct polarity is observed.
The plus sign on the battery must be visible when it
is installed.
3. Replace the battery compartment cover.
4.2 Installation (tabletop/wall)
NOTE: If you are connecting the device to a
television set, place the device centrally at the
bottom of the TV set.
Tabletop installation
1. Place the device on a level surface.
2. Connect the power supply unit
7 to the device.
Wall installation
WARNING! Risk of property damage!
When installing the device on a wall, please ensure
the following:
- The wall installation accessories must be
appropriate for the type and material of the wall. If
necessary, obtain and use other wall installation
than those included with the product.
- Make sure that the area of the wall in which
holes will be drilled contains no pipes or cables
(e.g. electricity, water, gas installation).