9
Step2: Open “EagleEyes” on your iPhone or iPad.
In the address book, click “+” to add new device. Then, select “Local Network Search” to search your
network camera. You’ll see an IP address assigned by your router.
If you connect two or more cameras to the wireless router, you’ll see many cameras with different IP
addresses after searching. To know which camera you’re configuring, you may identify each with its
unique MAC address.
Note:
The MAC address can be found on the sticker at the rear panel of the camera.
Step3: Select the IP address you want to
configure to show the IP address setting
page.
Switch the tab from “DHCP” to “Static”.
The default port number is 88. You may
change it to any value (such as 8080) if
the port number of 88 is blocked.
Then, note down the IP address and
port number you see here. You might
need them for port forwarding later.
Step4: Select “Apply” to confirm all your
changes. Then, wait till you see “
Done
”
or “
Fail
” in “Status”.
Regardless which message you see,
proceed as instructed below:
For
Done
, you’ll return to the new device
page.
For
Fail
, select “
” on the top right side.
You’ll later be prompted to select “DDNS” or
“Local IP”. Select “DDNS” and return to the
new device page.